Jerry,
The error tells me the file "contains null capable fields". When I display the file
it shows dashes if the field is blank. The error happens at the read statement. Any ideal
how I might get around this?
Thanks,
William...
-----Original Message-----
From: rpg400-l-bounces@xxxxxxxxxxxx
[mailto:rpg400-l-bounces@xxxxxxxxxxxx]On Behalf Of Jerry Adams
Sent: Friday, February 29, 2008 3:23 PM
To: RPG programming on the AS400 / iSeries
Subject: Re: Data mapping error
Did you review the previous error messages as described in the CPF5029
error message?
Recovery . . . : If the record number is zero, the error occurred on
an
attempt to put or update a record through a logical file, or the
error
occurred on a group by operation, or the error was caused by a
default
value, or the error was caused by a null value in the record.
See
previously listed message CPF5035 or CPD5036 to determine which fields
are
in error. Change the fields that are in error and try the operation
again.
If the record number is not zero, the error occurred on an attempt
to read
an existing record from a file. See previously listed message CPF5035
or
CPD5036 to determine which physical file fields are in error. Then
either
delete the record from the file or change the data in the fields that
are in
error. Then try your request
again.
* Jerry C. Adams
*IBM System i Programmer/Analyst
B&W Wholesale Distributors, Inc.* *
voice
615.995.7024
fax
615.995.1201
email
jerry@xxxxxxxxxxxxxxx <mailto:jerry@xxxxxxxxxxxxxxx>
Willie J. Moore wrote:
When I try to run program-A, I get the following error:
Data mapping error on member ONTIMED
CPF5029 I/O error was detected in ONTIMED (C G S D F)
This is the code and it failes at the read statement.
C READ ONTIMED LR
C LR GOTO WRKEND
Any ideals or suggestions would be appericated.
Thanks,
William Moore
midrange.com
