Connecting AS/400's SDLC PASTHR via Modem?

["Fred Pritchard" <pritch@xxxxxx>]

Hi All,

I am setting up a v.24 modem to dial another AS/400 for PASTHR.  I have
created the line, Controller, and Device.  When I vary-on the line with the
modem connected, it will go to connect pending and then fail and go to
RCYPND.  I can not figure out what is going on.  The message is as follows:

    Message . . . . :   Line UCFSLIN failed. Probable local modem problem.
(C G R)
    Cause . . . . . :   The system is trying to build a session with a
remote
      device and has received an error.  This is probably a local modem
problem.


     The error code is X'44001010':  Data set ready (DSR) was active from
the
     modem before the data terminal ready (DTR) was brought active by the
system.

I am unable to determine where the error is, the modem or my 400 configs.
If anyone knows of any manuals that I can use to look this up I would
greatly appreciate it.  I haven't been able to find anything on this.

Thanks for any assistance,

Fred

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---