Re: Connecting AS/400's SDLC PASTHR via Modem?

[James_Turnbull@xxxxxxxxxx]

Modem config.  Check the dip switch settings on the modem.  You need to ensure
the modem is set in the right mode.  Can you post Line, Controller, Device
configs and modem type / model?  I can confirm exactly what settings should be
then.

James Turnbull






"Fred Pritchard" <pritch@ee.net> on 17/09/99 07:37:14

Please respond to MIDRANGE-L@midrange.com

To:   "MIDRANGE" <MIDRANGE-L@midrange.com>
cc:    (bcc: James Turnbull/Sydney/KAZ/AU)
Subject:  Connecting AS/400's SDLC PASTHR via Modem?




Hi All,

I am setting up a v.24 modem to dial another AS/400 for PASTHR.  I have
created the line, Controller, and Device.  When I vary-on the line with the
modem connected, it will go to connect pending and then fail and go to
RCYPND.  I can not figure out what is going on.  The message is as follows:

    Message . . . . :   Line UCFSLIN failed. Probable local modem problem.
(C G R)
    Cause . . . . . :   The system is trying to build a session with a
remote
      device and has received an error.  This is probably a local modem
problem.


     The error code is X'44001010':  Data set ready (DSR) was active from
the
     modem before the data terminal ready (DTR) was brought active by the
system.

I am unable to determine where the error is, the modem or my 400 configs.
If anyone knows of any manuals that I can use to look this up I would
greatly appreciate it.  I haven't been able to find anything on this.
+---






+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---