Re: HMC and ASM

[Lukas Beeler <lukas.beeler@xxxxxxxxxxxxxxxx>]

On Mon, Aug 24, 2009 at 19:56, Dave Snyder<DSnyder@xxxxxxxx> wrote:
> I believe we at one point connected our HMC to the default ip address but
> then changed it. We are trying to connect via that same (the changed one)
> ip address and can ping it but not get to the ASM interface via the
> browser now, so that we can once again change it, Maybe we need to reset
> it - how do we do that without being in ASM.

What browser are you using? Older versions of the FSP firmware have
serious SSL compatibility issues with modern browsers.

Can you telnet to port 443 of the FSP IP address? If yes, then it's
most probably an SSL issue.

If not, try restarting the FSP (shutdown all LPARs, remove power from
the machine, power it up again).

In the worst case, you can reset the FSP to it's default settings -
however there are some important things that should be considered
before doing this. There's a little dip switch on the FSP card witch
after moving to the other position will completely reset the FSP. But
don't do this without reading the appropriate documentation.