Query processor failure

[Albert York <alfromme@xxxxxxxxx>]

I recently had to reload a system from scratch and now I am getting
the messages below when I try running WRKLICKEY or RMVLICKEY and other
processes that use the query processsor. Does anyone have any
suggestions how I can resolve this?

Thanks,

Albert


Message ID . . . . . . :   MCH5003       Severity . . . . . . . :   40
 Message type . . . . . :   Escape
 Date sent  . . . . . . :   03/14/11      Time sent  . . . . . . :   15:06:16

 Message . . . . :   Scalar operand contains a value that is not valid.
 Cause . . . . . :   The length of the invalid scalar operand is 1.  The bit
   offset to the invalid field is X'0000'. The operand number is 3.  The
   invalid data is X'0A'.

 Message ID . . . . . . :   CPF4204       Severity . . . . . . . :   50
 Message type . . . . . :   Escape
 Date sent  . . . . . . :   03/14/11      Time sent  . . . . . . :   15:06:16

 Message . . . . :   Internal failure occurred in query processor.
 Cause . . . . . :   A system failure has occurred in the query processor
   program.  The query definition template number is 1.
 Recovery  . . . :   See the low-level messages.  Correct any errors and try
   your request again.  If the problem continues, report the problem (ANZPRB
   command).