Re: HMC session hung

[Jack Kingsley <iseriesflorida@xxxxxxxxx>]

Did you start the shared key from the hmc itself.

On Tue, Aug 9, 2011 at 12:39 AM, ankush agrawal <aankush39@xxxxxxxxx> wrote:

> Hi All,
>
> Yesterday, I faced a strange issue. I was loading cum packages on system.
> System was in restricted state and i was accessing it through HMC. After
> loading packages, Go PTF option 8, my HMC session hung. I waited for about
> half an hour but it didn't come back. Then I disconnected the session and
> login to another HMC session. As I gave the session key, it threw below msg
> at the bottom of screen.
>
> 043 ; Connected, waiting for partition screen. But it didnt connect.
>
> Then, after an hour one of my colleague, logged in to HMC session and he
> disconnected my session and was able to connect. I checked the history logs
> and found below error messages:
>
> PTFs installed successfully.
> Local system sent SNA negative response data to controller CTL01 on device
> D
> Local system sent SNA negative response data to controller CTL01 on device
> D
> Local system sent SNA negative response data to controller CTL01 on device
> D
> Device DSP01 no longer communicating.
> Session stopped by a request from device DSP01.
> Device DSP01 no longer communicating.
> Device DSP01 no longer communicating.
> Device DSP01 no longer communicating.
>
>
> Message ID . . . . . .
> :   CPI5906
> Date sent  . . . . . . :   08/06/11      Time sent  . . . . . . :
> 03:03:13
>
>
> Message . . . . :   Local system sent SNA negative response data to
> controller
>  CTL01 on device
> DSP01.
>
>
> Cause . . . . . :   The remote system may have sent Systems
> Network
>  Architecture (SNA) data that does not conform to SNA protocols or
> the
>  configuration is not
> correct.
> Recovery  . . . :   If the controller is a host system, this may not be
> an
>
> error.
>    If the controller is a host-type controller, the remote system may
> have
>  more logical units varied on than there are device descriptions
> configured
>  or varied on and attached to the controller at the local
> system.
>    If the controller is an advanced program-to-program communications
> (APPC)
>  controller or host-type controller, verify the following device
> description
>
>
> Can anyone help me in understanding about the issue.
>
>
>
>
> Thanks,
>
> Ankush
> --
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.