Re: ipl

[Jim Langston <jlangston@xxxxxxxxxxxxxxxx>]

It sounds to me like your system is set up to automatically IPL when power
is restored, and since it was an abnormal end it is probably rebuilding access
paths and such.  There is an option, somewhere, to say whether to bring up
QINTER ass soon as it can, or to wait til access paths are rebuilt.

I would think it should be fine after all the access paths are rebuilt.  Check
QSYSOPR and see if it did an IPL, and there should be a message a little
farther down stating it's rebuilding the access paths.

Regards,

Jim Langston

Art Baker wrote:

> Guys,
>         I had a power failure last night. The result was the Ethernet device
> failing. I reset the Ethernet this morning and everyone can log on now, but
> the system is running very slow. Looking at WRKSYSSTS there does not seem to
> be a lot of activity yet it takes a long time for a response.
>         I did notice the AS400 display has a '01'. It usually says 01 and
> 'B'. The 'B' is missing. Does that mean anything?
> Art
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: david@midrange.com
> +---

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---