Re: V5r3 Service Director

[Thomas Hauber <thauber@xxxxxxxxxxxx>]

Which manual or manuals from the info center should we look at?

Thomas Hauber
Senior Programmer/Analyst
General Ribbon Corp.



Mike wrote:

> Mike,
>
> The Service Director at V5R3 is incorporated into 5722 SS1.  You no longer
> need the Licensed Program 5798 RZG.  It sounds like you are trying to start
> the old Service Director subsystem in your start up program.  End the old
> Service Director subsystem and remove it from your start up program.
>
> Once you have done that, do GO SERVICE and follow the instructions from
> there.  It will force you to do the setup.  I would HIGHLY recommend that
> you go to the Info Center and read how to do that.  There are some changes
> in there that you need to understand.
>
> <hth>
>
> Mike Shaw
>
> -----Original Message-----
> From: midrange-l-bounces@xxxxxxxxxxxx
> [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Condon, Mike
> Sent: Thursday, December 02, 2004 7:12 AM
> To: Midrange Systems Technical Discussion
> Subject: RE: V5r3 Service Director
>
> Yes, but pours was "broke" for some reason after our v5r3 upgrade - I
> need to set up/enable it.
>
> -----Original Message-----
> From: midrange-l-bounces@xxxxxxxxxxxx
> [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of rob@xxxxxxxxx
> Sent: Wednesday, December 01, 2004 3:36 PM
> To: Midrange Systems Technical Discussion
> Subject: Re: V5r3 Service Director
>
>
> I think it's "just there".  Check out the Memo to Users.
>
> Rob Berendt
>